Plymouth Coupe Sheet Metal Fabrication

The ’36 Coupe sheet metal fab work is nearing completion.

Time to tackle the dreaded . . . hole in the roof.

1936 Plymouth Coupe Metal Fabrication

We had to cut the hole in the roof even larger to clean-up the edges and make it straight. We took some new 20 gauge steel and put it on the template, added an extra half-inch for the step around edges, and now it has a flush fit.

Plymouth Coupe Sheet Metal Roof

The roof panel needed support so we bent up some half-inch Chrome Molly tubing. We shaped the tubing into place, welded tabs onto the body so that the tubing had a landing pad for the roof frame to be attached.


Upon completion Shane says . . . “That wasn’t so bad. . . “

Posted in Custom Metal Fabrication, FOR SALE: 1936 Plymouth Coupe
Tags: ,
Smartphone users call now

NHRA 8.50 Certified Vega FOR SALE

Test w/ NEW 427 SBC, 1/8 mile = 5.501 at 126.98 mph

NHRA Top Sportsman FOR SALE

Over 1200HP, best ET on the car was 6.58sec @ 214MPH.

Subscribe to the SHOP Blog via Email

Enter your email address and receive notifications of new posts by email.